In a message dated 1/13/99 5:11:53 PM Central Standard Time, pmaun_at_bitstream.net writes: > I paddle a Current Designs GTS. I am probably going to move and angle my > rear bulkhead to for several reasons including decreasing the volume in the > cockpit. Any tips on materials (or measuring the inside of the hull!) would > be appreciated. > Patrick, I would make a cardboard template around the outside of the boat with the appropriate angle in the spot where you want the bulkhead. Then just make a flat fiberglass board and cut it out a tad smaller than your pattern. Tack it in place with a couple of strips, then glass tape it in. Rob *************************************************************************** PaddleWise Paddling Mailing List Submissions: paddlewise_at_lists.intelenet.net Subscriptions: paddlewise-request_at_lists.intelenet.net Website: http://www.gasp-seakayak.net/paddlewise/ ***************************************************************************Received on Wed Jan 13 1999 - 17:15:02 PST
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:03 PDT