In a message dated 9/25/99 7:09:30 PM, peterw_at_usa.net writes: << I'm guessing I have two basic options: - fill the crack where the chip has started to separate with some sort of glue (is regular mix-your-own expoy OK?) to reinforce the paddle and keep it intact - carefully cut the separating material off, just so nothing is sticking up from the face, and then use some epoxy to reinforce the paddle (a trim-and-spackle approach) >> I found Marine Tex did a fantastic job on my paddle and it sands down to invisible if you do it well. Just mend it and then sand all the extra off. I'd leave the raw part until then. More for the Marine Tex to bond to. Joan *************************************************************************** PaddleWise Paddling Mailing List Submissions: paddlewise_at_lists.intelenet.net Subscriptions: paddlewise-request_at_lists.intelenet.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Sat Sep 25 1999 - 19:05:07 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:13 PDT