[Paddlewise] Romany repair: leaking stern compartment

From: Robert C. Cline <rccline_at_swbell.net>
Date: Wed, 12 Jan 2000 09:54:08 -0600
The stern compartment of my Romany Explorer is seeping water.  I suspect the
rubber housing that encloses the skeg string.  Before my attemted repair,
the stern was "gushing" water: after a few hours of paddling, I would take
on several liters of water.  I replaced the rubber hose and clamps.  Now, I
only get some seepage.  After a couple of hours of paddling and roll
practice, the aft compartment is wet, with a couple of milimeters of
standing water.  I suspect it is from the same area.  The first repair
reduced the leakage, but hasn't stopped it.

The glassed-tubular housing that is a attached to each deck is slighly oval,
not round, where the rubber hose attaches.  I suspect the oval tube prevents
a good, water-tight, seal.

*Any suggestions* as to how to firm up the seal and stop the leak?  Aqua
lube?  Duct-Tape? Seal Cement, then wrapped with duct tape?

I've examined the hull at the skeg housing and do not see any signs of a
crack.  There are a few chips in the gel-coat, but nothing to indicate a
crack.

Thanks,

Robert



***************************************************************************
PaddleWise Paddling Mailing List - All postings copyright the author and not
to be reproduced outside PaddleWise without author's permission
Submissions:     paddlewise_at_lists.intelenet.net
Subscriptions:   paddlewise-request_at_lists.intelenet.net
Website:         http://www.paddlewise.net/
***************************************************************************
Received on Wed Jan 12 2000 - 07:55:35 PST

This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:18 PDT