>So why did CLC drop the Yare design? > >Other than the fact that even the crew at the CLC shop was usually hard >pressed to avoid building knuckles into the transitions from round bottom >midsection to the V-shaped ends ... Two ways to get round that - make a "funny" shaped keel line on the two planks or "fill it in". I used the latter method, adding 3 mm of ply along the "hollow" and grinding/fairing it back to a straight line keel. Alex . . Alex (Sandy) Ferguson Chemistry Department University of Canterbury New Zealand *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Wed Feb 21 2001 - 14:59:27 PST
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:37 PDT