Hi, Does anyone have any tips on getting the frame centered inside the hull of a Feathercraft K1 during assembly? I end up spending a good deal of time fidgeting with trying to get the keel bar and deck bar centered on the fabric, only to have it nowhere close when I do the final spreading of the bars in the cockpit. This results in having to loosen the bars again and fidget for another 10-15+ minutes trying to get it centered again. The entire boat goes together effortlessly except for this one issue, which I'm spending a good 20+ minutes on in construction time. Any tips/tricks from the expert folder community is most appreciated! TIA, Woody *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Sun Feb 25 2001 - 10:38:17 PST
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:38 PDT