In a message dated 3/9/2001 10:33:26 PM Eastern Standard Time, michaeldaly_at_home.com writes: > Any ideas on how to remove [decals] without damaging the gelcoat? > Use a hair dryer or heat gun. Works fine. Work slowly and you won't have a lot of gunk to clean off as a second phase. You'll have some, no matter what you do. Try alcohol, and if that doesn't do it, work up to a heavy duty commercial adhesive remover. Hardware stores will have that. Goof-Off works well, too, but wipe it up right away. Jack Martin *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Fri Mar 09 2001 - 22:16:01 PST
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:38 PDT