Patrick, For the best cut, I'd use an abrasive cut-off wheel in my miter saw (10" slide compound). This will have a slightly larger kerf than a hacksaw blade, but the cut will be smooth and straight... Harry Shin -----Original Message----- From: Patrick Maun [mailto:pmaun_at_bitstream.net] Sent: Monday, March 19, 2001 2:05 PM To: PaddleWise_at_paddlewise.net Subject: [Paddlewise] How to Cut a Paddle in Half Hey all, I need to cut a paddle in half (fiberglass shaft). I am getting it converted to a two piece. Anyone have any tips on the type of saw/blade to use? Thanks! -Patrick *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ *************************************************************************** *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Tue Mar 20 2001 - 10:45:57 PST
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:39 PDT