This stuff should work fine for your ferrules. One word of caution, though. NEVER uses this stuff unless you are sure you NEVER want the parts you're gluing to come apart. If you drip, smear or otherwise get this stuff where it doesn't belong (and it's easy to do because it's very sticky) clean it up right away with the solvent suggested on the label. Once it cures, nothing will get it off. For less permanent applications 3M 4200 might be a better choice. Brian *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:33:21 PDT