I initially made a seat out of minicell layered with neoprene (for wear resistance) but I was never very happy with it. I eventually purchased a foam seat made by Valley for their plastic boats. It comes with "ears" which I removed. The seat is pre-shaped and I wedge it between the hip pads and it stays perfectly. I've used it for 3 years or so and it is still going strong. I believe it runs around $50 and no muss, no fuss heh heh.... cya *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Wed Apr 11 2001 - 08:45:13 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:41 PDT