Re: [Paddlewise] fitting foam seat into boat

Dave said:
<snip>

Actually, I am trying a new technique:  "dots" (about 1/2 inch in
diameter) of
3M's ScotchWeld (3532) two-part polyurethane adhesive near the corners
of the
seat.  I figure I can easily slide a single-edged razor blade under an
edge to
remove the seat if I need to reposition it .  When I'm sure the seat is
done, I
will use more of this stuff.  It's really a terrific adhesive.
---------------

1. If a seat can come out with reasonable provocation, one's vesel is
not seaworthy, IMO (based on experience).

2. I'll have to look into that ScotchWeld adhesive. Sounds superior
dude. I wonder if Scott of So Cal uses it. He says he never comes out of
his kayak. Must be using the old CrothWeld adhesive. 8-)

DL

***************************************************************************
PaddleWise Paddling Mailing List - Any opinions or suggestions expressed
here are solely those of the writer(s). You must assume the entire
responsibility for reliance upon them. All postings copyright the author.
Submissions:     PaddleWise_at_PaddleWise.net
Subscriptions:   PaddleWise-request_at_PaddleWise.net
Website:         http://www.paddlewise.net/
***************************************************************************