Dave Kruger wrote, RE: fixing a kayak seat in place with Velcro - <<I have also made use of Velcro to fix the foam to the hull, but discovered that it takes more than four 2-inch squares to hold firmly. >> Right Dave. I use a strip 2 in wide and about 8-10 inches long on each side of the seat. I place the strips about 2.3 of the way between the keelson and the edge of the seat, though I don't know if that's the best placement or not; it just seems to work for me. If the bottom of the boat is prepped well, and if I use 2 or 3 coats of Weldwood contact cement, those strips will hold up through at least 4 to 6 changes of seat position and at least 3 years of reasonable use. Beyond that, I can't say. *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:33:21 PDT