In a message dated 4/30/01 10:00:56 PM, JSpinner_at_aol.com writes: << 3. I'm assuming that you are sealing them with a Cap on the fore end (of the boat, not the tube) and a plug on the aft end - correct?>> not sealed. The back is close to the front bulkhead so stuff can't go all the way through. >> I forgot to say that I drilled two holes and put thin bungie cord across to hold in the pump. No way can the paddle float fall/float out if the pump is there but I've found it easy to pull out with the pump in there. Roll the tube of the float inside to keep it from snagging. Joan *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:33:22 PDT