Lots of foam fitting experience out there. To the list of dragon teeth sand paper, sand paper, electric knife, wire brush, and shaper I would add; band saw, hacksaw blade (without frame) and those small rotary rasps you put in a drill. All but the band saw and sharp knife leave a fuzzy surface. That can be dressed up with a heat gun. Besides looking better, the smoother surface uses less glue. JKL *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:33:21 PDT