From: "anonymizer" <td376_at_mail.anonymizer.com> > Also, should I put in a 1/4" to 3/8" strip of foam of some > type around the perimeter of the bulkhead to eliminate a hard point between > the bulkhead and the hull? If you do that, the bulkheads will not support the deck as you would like. The best thing would be to build up a fillet of fiberglass to hold the bulkhead and spread the load to the deck and hull. Mike *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Sun Jul 14 2002 - 15:19:18 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:54 PDT