> Any suggestions on how to glue on a replacement graphite ferrule. I'm > concerned that with contact cement it would set before I got it all the way > on and lined up. If you soak the contact cement in lacquer thinner(after application) It will give you a few seconds before it sets. I've only used this to glue foam tires around plastic rims for RC cars, it's a tight fit , but the foam stretches. I don't know how it will work with a tight ferrule. *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Wed Aug 07 2002 - 10:40:22 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:57 PDT