From: "Kevin Zembower" <kevinz_at_fellspt.charm.net> > Not sure if this would work or not. Any other ideas > of how to attach D-rings to the inside of the hull in such as way that > they can still be laid flat against the surface? 3M 5200! I used it on home made D-rings (plastic D-rings held with webbing stitched to Cordura squares) and it's still there several years later. However, I glued it to the ABS bulkhead and not to the fiberglass hull. I don't see why it would not work with commercial D-rings on a glass hull. Don't get the rigid plastic plate; use the flexible Hypalon or vinyl backing. http://www.riverraiders.com/accessories/whitewater/whitewater.html Scroll down and there's an illustration of these D-rings. The two in the upper left are narrow rectangular strips - these are rigid plastic. The others are flexible. Mike *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Mon Aug 19 2002 - 13:55:51 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:58 PDT