Re: [Paddlewise] Latex Cuffs - How Tight?

Hi,

Latex gaskets on paddling gear are to tight for most people, from the 
shelf they need to fit the few with small wrists, necks, and ankles. 
We other have to cut them back to fit us.  As you will notice the 
gaskets taper towards the opening, so by cutting rings of the end 
they get gradually wider, till they fit comfortably.  Use really good 
sharp scissors and cut only a few mm at a time.  Then try the fit, 
till you don't get strangulated anymore.  Fit should be tight, but 
not cutting off blood flow. When cutting make sure to get a clean 
cut, little nips could turn into a starter for a ruptured gasket.

Stripping down a paddling jacket, dry top, or dry suit can be very 
entertaining for bystanders. Take advantageand put a your hat in 
front of you, tell them that you are a busker and that you do that 
for your living, then ask for a donation for showing them your escape 
from the straight jacket....

Ulli

***************************************************************************
PaddleWise Paddling Mailing List - Any opinions or suggestions expressed
here are solely those of the writer(s). You must assume the entire
responsibility for reliance upon them. All postings copyright the author.
Submissions:     PaddleWise_at_PaddleWise.net
Subscriptions:   PaddleWise-request_at_PaddleWise.net
Website:         http://www.paddlewise.net/
***************************************************************************