"Patrick Maun" <patrick_at_patrickmaun.com> wrote: >There is also Eddyline with Modulus Technology, Kevlar or fiberglass inside a polycarbonate (Carbonlite 2000*) shell instead of gelcoat >HTP from Prijon, HTP is their acronym for blowmolded polyethylene. Rather than rotomolded, where a bunch of plastic pellets are dropped into a hot, rotating mold, and melted into a boat; blowmolding involves a hot blob of molten plastic inside a cold mold. A blast of hot gas is injected into the blob, and it expands to fill the mold. When the hot plastic hits the cold mold, the plastic cools instantly into a "crystalline" molecular structure, which is much tougher and stiffer than a rotomolded boat which is cooled slower. Milk jugs and polyethylene soda bottles are both made of the same plastic. Milk jugs are made in a fashion similar to rotomoulding. Soda bottles are blowmolded. Couldn't tell you about Azul kayaks, never seen one. Some of them look a little funky to my eye--not that Corran Addison isn't a masterful whitewater kayak designer..I sometimes wonder if most of their focus isn't on the ww kayaks, and they're just trying to cash in on the sea kayak market with Azul. But I could be wrong (and have been before!). Shawn __________________________________________________ Do you Yahoo!? Yahoo! Tax Center - forms, calculators, tips, more http://taxes.yahoo.com/ *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:33:33 PDT