Re: [Paddlewise] Feathercraft assembling skin Q

> Sounds like you are going to the third hole when perhaps you only need to
go
> to the second hole.
>
> I have a 2002 Feathercraft K-1 and my K-1 instructions say go to the
second
> hole.  (1) I start with the keel bar and go to the 1st hole, (2) then I do
> the two chine bars to the 1st hole (3) then I do the gunnel bars going
> directly to the second hole (4) I go back to the keel bar and put it into
> 2nd hole  (5) then I go to the chine bars and put them into the 2nd hole.
>

Oddly enough, but I can't extend the cockpit keelsen  bar even to the 2nd
hole.  Stern frame half is on the 3rd hole (i.e. the longest set of frame
half) , though.  Manual for Big Kahuna recommends 3rd hole for a rame half,
and so I did.
Alex.

***************************************************************************
PaddleWise Paddling Mailing List - Any opinions or suggestions expressed
here are solely those of the writer(s). You must assume the entire
responsibility for reliance upon them. All postings copyright the author.
Submissions:     PaddleWise_at_PaddleWise.net
Subscriptions:   PaddleWise-request_at_PaddleWise.net
Website:         http://www.paddlewise.net/
***************************************************************************