Leonhardt, William J wrote: > I confess that I haven't followed this whole thread (could become a hole > thread) but here is an additional thought. If you want to move your > footpegs and NOT drill additional holes, you could do it with a spacer > plate. You would unscrew the screws that currently hold your footpegs > and install a long, thin plate with the same screws and hole pattern > where your footpegs are now. This spacer plate would also have a tapped > hole pattern to remount your footpegs in a new, more-suited-to-you > location. New screw lengths would have to be chosen carefully, but, in > the end, you would get the footpegs in a new location without additional > hull holes. AND, you could put the boat back to the way it was for resale. Ooooh! This guy is good! I like this idea. At least it gets my mind working in more dreative directions than it was before. GryJ -- Director, Family Canoeing Centre Recreational canoeing courses for the whole family. +--------------------------------+ | /"\ | | \ / | | X ASCII RIBBON CAMPAIGN | | / \ AGAINST HTML MAIL & NEWS | +--------------------------------+ *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Thu Jun 05 2003 - 13:15:27 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:07 PDT