> > I proport again Use Aquarium Sealant! A lot less expensive than > > 3M, and does the same thing. > > Works fine until you need to do a hull/deck repair there. Then the silicones > from the aquarium sealer will make adhesion of either epoxy or polyester > resin difficult or unreliable. I didn't notice any mention of the hull material, but would suspect that this is important too. Are you guys talking of fiberglass or poly? How about good adhesive for poly - not necessarily flexible? Alex. *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Tue Jun 10 2003 - 23:55:50 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:07 PDT