After my automotive establishment garage door ramming session last week I picked up some web/cam based tiedows, as my home made ones weren't as strong as they should be given I was using plastic "D" rings for the "V" section where the ties goes left and right to spread the load. A sample is below: http://www.bushwhackeronline.com/tiedown.html There was some discussion on this subject a while back. I believe one poster mentioned drilling eye bolts into the bumpers of this Chrysler Minivan. I'll be doing the same -- after all, vehicles are meant to serve us, not look pretty and un-festooned by pragmatic based needs. Doug Lloyd Victoria BC ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~~~~~~~~~ "Whatever can be said at all can be said clearly and whatever cannot be said clearly should not be said at all." Ludwig Wittgenstein ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~~~~~~~~~ *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Sun Jun 15 2003 - 20:14:37 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:08 PDT