Don't have my cart's photos on website, so here is the idea (cart on the blue backgorund near the bottom of the page): http://www.stripersonline.com/ubb547/Forum6/HTML/001359.html : My cart has 3 parts: 2 supports made of aluminum tubes 1"OD welded at right angle in shape of "T", and 1' * 1/2" stainless rod that goes through the holes drilled at the bottom of these T's. Plus, of course, golf cart wheels, straps and vinyl tubes over aluminum tubes (royalties please to Alex Fergusson in NZ). Most golf cart wheels have axle holes *close* to 1/2", so make sure it fits your stainless rod before ravaging some $20 used or $40 new golf cart :-). Folds into pretty compact parts. Next page on this wesite, btw, shows some neat carts with "baloon" Roleez wheels and frame made of a dozen or so plumbers PVC joints. Too many parts, I think. > http://www.geocities.com/gwchitty/kayakpics/carts.jpg > http://www.geocities.com/gwchitty/kayakpics/boatbuilding/01complete_gear.jpg *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Tue Jun 22 2004 - 23:44:28 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:15 PDT
