The resin will out-gas for a long time. The best you can probably do is put the boat in the hot sun with all the hatches open to accelerate the out-gassing. You could also put an old stinky wetsuit in there, it may overpower the resin smell. Nick On Mar 5, 2005, at 12:15 AM, John Kirk-Anderson wrote: > I have just done some fibreglass work inside my Nordkapp, and with a > week-long trip starting in a couple of days I want to reduce the smell > of > cured resin. > > I will give it a good flush with water once the sanding is complete, > and > leave the VCP hatch covers off until I go, but any suggestions on > speeding > the process would be welcome. *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Sat Mar 05 2005 - 17:33:49 PST
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:19 PDT