Re: [Paddlewise] your paddlewise post

-I have only done this on linear polyethelene (roto molded boats)
-Boiling water and a bath towel...
-Place bath towel over and extending beyond the size of dent folded into
several layers on INSIDE of kayak.
-Pour boiling water onto towel so the combination of continuous heat and
the weight of towel and water will likely push the dent out to its
original shape or mold memory. If it doesn't pop out, gently push it out
with hand (as temperature allows) or some other large shaped object.
(2X4 block of wood)
-Let cool and remove towel and excess water
-Voila
Obviously the dent and towel etc should be on the bottom side for this
to work properly...
Pat
***************************************************************************
PaddleWise Paddling Mailing List - Any opinions or suggestions expressed
here are solely those of the writer(s). You must assume the entire
responsibility for reliance upon them. All postings copyright the author.
Submissions:     PaddleWise_at_PaddleWise.net
Subscriptions:   PaddleWise-request_at_PaddleWise.net
Website:         http://www.paddlewise.net/
***************************************************************************