Need to epoxy a small piece of wood to the previously varnished surface (and probably put a screw through this joint). I know that epoxy can be covered with a varnish, but somehow it feels that I should remove the varnish (I have a lacquer thinner), if I apply epoxy first. The piece is small, the stress will be low (and there will be a screw), the joint (on the top of a cockpit rib) will be dry most of the time, - so may be varnish alone will be enough. I just like using epoxy whenever possible. Alex. *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Sat Jun 25 2005 - 19:56:01 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:21 PDT