I once repaired an radiator overflow container on a GMC van using milk jug strips and a soldering iron. No leaks and it held up for about 12 years and was still good when we got rid of the van. Since molded kayaks are of the same material as milk jugs, I would try a repair. It was really not that hard. Practice on something until you get your technique down. Maybe buy some plastic rods and use them like you are brazing. Good luck on the repair. *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:33:42 PDT