I am working on building an electric pump system. I plan to put the batteries in a small pelican case. How do you get the power cord out of the case? I could run the cord out through the side of the case opening, but am concerned that I may be introducing a leak. I could drill through the case, and put sealant around the wire. What methods have been found to be satisfactory? Thoughts? Derek --------------------------------------------------------------- Please limit all email attachments sent to this address to a maximum of 0.5MB. All email attachments that are larger then 0.5MB will automatically be deleted. --------------------------------------------------------------- ICQ: 262152266, AIM: GlamourpetsD, MSN: [my email address], Yahoo Messenger: glamourpets --------------------------------------------------------------- *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Fri Oct 06 2006 - 18:12:08 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:21 PDT