> From: John Fereira <jaf30_at_cornell.edu> > Is it possible to load multiple maps (assuming the > unit has enough memory) and switch maps using the unit? Yes it is. Since I have the older 76CS (got it when it first came out) loading all the maps I need and then selecting which map to view is what I have done. There is also a ranking the unit uses to select which map to show by default (you can't change it). Street maps come first, then the topo maps, then the base map that comes with the unit. Not sure where the bluecharts rank since I don't have any (I don't paddle the coast). When I go the BWCA I load the street maps for the drive there and the topo maps for my canoe trip. When I go to put in I go through and turn off the street maps for upper MN so that the topo maps will appear. On the map screen bring up the menu, move over to the menu item that shows what maps are loaded. Then scroll through the individual maps and toggle off the street maps covering up your topo maps. Mel I'm not insane, but my other personality is. *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Fri Jan 05 2007 - 06:17:05 PST
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:22 PDT