[Please remove all old content that is not pertinent to your reply including old headers and footers. It's list policy.... this post was modified to meet policy] From: "Doug Lloyd" <douglloyd_at_shaw.ca> > Did the glue joint delaminate, or was it split just above or below the > overlap joint? It was a failure of the glue joint. I notice on my new boat you can see a couple screw heads throught the seam tape that I didn't notice on my first boat. Perhaps along the lines of the rivet use in aircraft. I figure the narrow bow and stern might be the weak link in getting pressure on the two surfaces while the glue cures. Mark *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Sun Apr 08 2007 - 15:44:23 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:24 PDT