Re: [Paddlewise] Paddle float storage

cholst_at_bitstream.net wrote:

> I use homemade fittings. You will need four:

Holy cow - you have a lot of time on your hands :-)

My approach was simpler.  My paddle float has a Fastex buckle to close 
it around the paddle shaft.  I use this to attach to the rear of the seat.

I get a matching Fastex buckle and make a loop of webbing to attach each 
half of the buckle to either side of the seat back (you could wrap the 
webbing around the seat pillar if you want.  Then I just roll up the 
paddle float and wrap it in a rubber band to keep it rolled.  Clip the 
buckle halves on the paddle float to the halves on the seat and you're 
done.

<http://www.greatlakeskayaker.ca/paddleFloatAttach.htm>

Mike
***************************************************************************
PaddleWise Paddling Mailing List - Any opinions or suggestions expressed
here are solely those of the writer(s). You must assume the entire
responsibility for reliance upon them. All postings copyright the author.
Submissions:     PaddleWise_at_PaddleWise.net
Subscriptions:   PaddleWise-request_at_PaddleWise.net
Website:         http://www.paddlewise.net/
***************************************************************************