Dickson, Dana A. wrote: > What about drilling a hole, just large enough to take a locking cable, > in the blade of the paddle. You would lose some paddle efficiency, but > that, IMO, is better than compromising the strength of the shaft. > > So who will speak against holy paddles, or should I say holey? Wouldn't you want to drill one in both blades, to keep your stroke symmetrical? ;) Steve -- Steve Cramer Athens, GA http://www.savvypaddler.com *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Fri May 18 2007 - 06:21:02 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:24 PDT