Dave Bishop wrote: > how to secure the loops in the rudder end of the cables. If they are metal cable, go to the marine supply store and get some little copper sleeves to fit the cable. Run the cable through one side of the sleeve, form the loop, and run the end through the other side of the sleeve. Crunch it closed with vise grips, or use the tool at the marine store. Some folks like to pre-thread some shrink tubing, and then cover the bare end of the cable with it. -- Dave Kruger Astoria, OR *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Fri Jun 22 2007 - 20:56:55 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:25 PDT