Wow, Steve you are good! Visual aids along with your post! You are seeing part of my problem. Although I've been trying to keep the end of my painter a little tighter under the bungies than it shows in that photo, I still would like to keep it loose enough that it would self deploy when I need it. You have also diagnosed a problem with my roll that I'm very aware of. I have so little flexibility that I can't get my paddle very high on my set up, but it's something I just try to work around. My loose painter just adds a bit of suspense to the whole situation. You can see how I use my painter at the end of this video: http://www.youtube.com/watch?v=HjWXFCdL-X4 Mark Sanders -----Original Message----- I found a picture of Mark and his painter at http://duane.smugmug.com/gallery/2378334#124618259_xexGH It looks like it runs back from the bow toggle and is clipped to the rearmost bow deck bungee on the left side. Mark, do you set up to that side? It seems to have a certain amount of slack, so it will hang several inches below the deck when capsized, potentially causing problems. If it does, it may be an indication that Mark is setting up with the paddle lower in the water than optimum. With a little more tuck, the paddle would be against the hull, not the deck, and would be clear of the painter. Or you could shorten it so that it clips to the front of the bungees, not the back, since why would you need access to it from the cockpit? Steve Cramer Athens, GA http://www.savvypaddler.com *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Fri Apr 25 2008 - 15:42:53 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:29 PDT