These days when I paddle out of Newport, there's always a flotilla of boats at anchor that are just calling to be my next home. This one is my favorite: www.sandmarks.net/HomeSweetHome.jpg They'd all need a vat large enough to dip the whole boat into the penetrating epoxy though, that may be a problem! Mark -----Original Message----- You can literally spray it into a small hole where its viscosity is such that it will then flow down into the substrate and invade the dry-rotted wood. When it cures then it's hard. It helps to use compressed air or something to dry out the wood. *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Tue Jul 15 2008 - 19:53:45 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:30 PDT