Does anyone make one of these with all the parts in stainless? I paddle and ski with one in my first aid kit, but replace it every few years due to severe rusting of the release mechanism. The blade rust is no big problem -- I just sand it down. The problem is that the release mechanism for the folding blade rusts and jams up. Richard Culpeper -----Original Message----- From: owner-paddlewise_at_paddlewise.net [mailto:owner-paddlewise_at_paddlewise.net] On Behalf Of Rich Kulawiec . . . Finally, whenever doing something creekish, I have this nasty piece of work in my drybag: http://www.fiskars.com/webapp/wcs/stores/servlet/ProductDisplay?storeId=1000 1&langId=-1&catalogId=10101&categoryId=10263&productId=10520&page=products Why? Because it can saw through a kayak or canoe. And because it's cheap enough (under $15) that even if I only use it once, it's worth the cost and the effort to lug it around for years. *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Wed Aug 11 2010 - 11:19:46 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:43 PDT