RE: [Paddlewise] 5200 Red

I was surprised, but yes, I was able to peel the old 5200 off the hull. I
had cleaned it with acetone and roughed it up with 80 grit.

cya

-----Original Message-----
From: owner-paddlewise_at_lists.intelenet.net
[mailto:owner-paddlewise_at_lists.intelenet.net]On Behalf Of Dave Kruger
Sent: Thursday, May 18, 2000 2:44 PM
To: PaddleWise
Subject: Re: [Paddlewise] 5200 Red


Bob Denton wrote:
> 
> I used 5200 fast set (24 Hours) and noticed I was able to peel the old
stuff
> off the hull when I re-glued my foam foot rests. Is this stuff less
adhesive
> then the regular 5200?

Ooops!  I did not read your post carefully before I initially responded,
Bob. 
So the 5200 is losing its bond to the fiberglass?  Do I have that right?

If so, I suspect surface preparation is the culprit.  Even the fast-set
stuff
is incredibly adherent, in my experience.

-- 
Dave Kruger
Astoria, OR
chemist
***************************************************************************
PaddleWise Paddling Mailing List - All postings copyright the author and not
to be reproduced outside PaddleWise without author's permission
Submissions:     paddlewise_at_lists.intelenet.net
Subscriptions:   paddlewise-request_at_lists.intelenet.net
Website:         http://www.paddlewise.net/
***************************************************************************
***************************************************************************
PaddleWise Paddling Mailing List - All postings copyright the author and not
to be reproduced outside PaddleWise without author's permission
Submissions:     paddlewise_at_lists.intelenet.net
Subscriptions:   paddlewise-request_at_lists.intelenet.net
Website:         http://www.paddlewise.net/
***************************************************************************