Neat site, Gabriel! For Jim --- nothing even close to those on the site, but a thought. Depending on how much weight you were trying to keep in place, and on the configuration of the volume of the space in which you wanted to place the balast --- I'm assuming you're trying to trim the boat with different balast configurations, and this is temporary --- there may be another option. You may be able to hold balast in place by locating it where you want it and then insert and inflate a relatively strong beach ball inside the area and above and around the weight so that the balast is held in place. Not good for a long test, because the ball will leak over time --- or heat up and explode! --- but, in the short run, it will hold a fairly substantial weight in place for trimming. For Gabriel: I assume you *don't* want a picture of this! Jack Martin *************************************************************************** PaddleWise Paddling Mailing List - All postings copyright the author and not to be reproduced/forwarded outside PaddleWise without author's permission Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Sun Sep 03 2000 - 18:07:05 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:31 PDT