While I have not cut down a Lendal blade, I did once do some repairs on a friend's Lendal blade. I see no reason why you couldn't successfully cut it down. You might separate the laminations a little as you cut it down, so cut a little proud of the line and sand down the remainder. Nick At 8:51 PM -0500 2/8/01, Michael Daly wrote: > >Has anyone ever cut down such a blade (in width)? Any obvious problems? > >The Lendal blades are, I'm told, solid, not hollow, so this is a possibility. -- Nick Schade Guillemot Kayaks 824 Thompson St Glastonbury, CT 06033 (860) 659-8847 *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Fri Feb 09 2001 - 06:40:17 PST
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:37 PDT