Many thanks to all who provided help!!! Summarized here were the results to me major question, and everyone said the same thing... Gabriel L Romeu "...my first coat soaks into the wood and has no apparent thickness." Dave Kruger "Don't be afraid to roll out the saturation coat. You are only trying to fill the pores." Nick Schade "You only need to apply enough to make the wood appear wet. Don't try to build up any appreciable thickness." "General" recommendations included - Use short nap or foam rollers to apply - Try heating the surface, ensuring that it cools as the epoxy is applied - Use dense foam brushes, as open foam brushes tend to disintegrate Thanks again for the help. Aaron *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:33:20 PDT