RE: [Paddlewise] Pumps

From: Peter Treby <ptreby_at_ozemail.com.au>
Date: Tue, 13 Mar 2001 14:27:24 +1100
"Any of you Rule 500 types (or folks with any pump that does not have a
built-in check valve) come up with a happier solution?"
Another solution, maybe not happier, just place a cork or bung (on a short
tether) in the deck / skin outlet. If it's fitted just firm, not tight, it
pops out on its tether when the pump starts.
Remember to replace it afterwards. Water enters the cockpit through the pump
otherwise.
This bung set up is used quite a bit here. The plastic topped cork used on a
reasonable bottle of vintage port fits a 3/4" outlet OK, but be sure to
provide yourself with a few spares.
PT
37º 42' S  145º 08' E



***************************************************************************
PaddleWise Paddling Mailing List - Any opinions or suggestions expressed
here are solely those of the writer(s). You must assume the entire
responsibility for reliance upon them. All postings copyright the author.
Submissions:     PaddleWise_at_PaddleWise.net
Subscriptions:   PaddleWise-request_at_PaddleWise.net
Website:         http://www.paddlewise.net/
***************************************************************************
Received on Mon Mar 12 2001 - 19:14:02 PST

This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:38 PDT