PaddleWise by thread

From: Kathea and Ken <kayakfit_at_fidalgo.net>
subject: [Paddlewise] Fw: Paddlefloat
Date: Wed, 21 Nov 2001 19:09:59 -0800
Ken Rasmussen


kayakfit_at_fidalgo.net


www.kayakfit.com


    I've been enjoying all the responses to my original posting.  As to Sid's
challenge, I would win if and only if I had a fast electric pump.  His speed
on the T rescue is commendable.  I can do a paddle float rescue faster
(usually 30 seconds), but I've still got water in the boat.  My boat does
function well with water in the cockpit due to the sharp V hull and the bow
and stern flotation, but that is not true of most kayaks.  


    I would award the points this way:  


        Rolling is best in all respects.  


        Assisted rescues properly done, are stable, fast, and result in a dry
boat.  However a victim has little control over the expertise, proximity, or
availability of a rescuer.  


        An optimised paddlefloat rescue is faster than an assisted rescue
(except the Eskimo rescue), but still requires pumping.  The paddlefloat
rescue is less stable than an assisted rescue.  An unoptimised paddlefloat
rescue is poor in all respects.  


        Re-enter and roll, and re-enter and roll with a paddle float are fast
and stable rescues, but require the ability to roll.  Generally a person who
rolls well won't need either of these rescues, and a person who can't roll,
can't use them.


    I would like to re-emphasize that with my foam float, the paddle is
inserted into the float before the float is detached from the kayak, thus the
kayak and the float are a unit until the float and the paddle have become a
unit.  


    Great commentary, all of you!








***************************************************************************
PaddleWise Paddling Mailing List - Any opinions or suggestions expressed
here are solely those of the writer(s). You must assume the entire
responsibility for reliance upon them. All postings copyright the author.
Submissions:     PaddleWise_at_PaddleWise.net
Subscriptions:   PaddleWise-request_at_PaddleWise.net
Website:         http://www.paddlewise.net/
***************************************************************************
From: PeterO <rebyl_kayak_at_iprimus.com.au>
subject: [Paddlewise] Paddlefloat - removing water unassisted
Date: Thu, 22 Nov 2001 17:08:33 +1100
Matt wrote
>I question if anyone can pick up  the front (and break the suction
>at the cockpit) of even and empty (swamped) sea kayak using merely
>a scissors kick to do so. (Paddlewise's Robert Livingston and his
>Ursa 350 possibly excepted). Now, this belief of mine may just be
>because I have used bad technique when trying to do it. If so,
>please instruct me in how it is done.

G'Day Matt and Paddlewise,
	I partially emptied boats by sitting on the rear of the inverted boat.
Couldn't succeed by lifting the front. Also have partially emptied boats by
going to the side, reaching underneath the cockpit and grabbing the coaming
with one hand on the opposite side and one on the near side and using a push
pull rotate action to lift one edge out of the water before flipping it
over - guess just about everyone does this. Neither method gets rid of all
the water - do you or anyone else know of better ways to empty a boat
unassisted before self rescuing? Alternatively any hints on putting a spray
deck on upside down in the water?

Thanks for any advice you can give, PeterO




***************************************************************************
PaddleWise Paddling Mailing List - Any opinions or suggestions expressed
here are solely those of the writer(s). You must assume the entire
responsibility for reliance upon them. All postings copyright the author.
Submissions:     PaddleWise_at_PaddleWise.net
Subscriptions:   PaddleWise-request_at_PaddleWise.net
Website:         http://www.paddlewise.net/
***************************************************************************

This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:33:25 PDT