> My specific application is for adding closed cell foam inside the cockpit, and for adding some "D" rings behind the seat to secure "stuff" and "D" rings inside the hatches to secure partial loads. OK, not a repair - just an adding. My first choice would be Sikaflex 291 (for Distributor try a google-search). But there is a similar one from 3M, forgotten the name. Glue based on Polyurethane which is very flexible. The Sikaflex 291 gots a maritime approvement (or something similar, donīt know the right word for it). But the more important point might be the surface preparation. Clean it as good as possible, even with white gas. Make some little scratches in the PE, so the glue gets more grip. happy gluing Jochen *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Mon Jan 07 2002 - 13:41:43 PST
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:48 PDT