I have a Dagger Delta which is similar in size & shape and is made of the same foam/skin as the Blackwater. The bulkhead is Minicell, about 1-1/2 or 2 inches thick. Not sure what the adhesive was, but it looks to be something like Marine Goop. (I often use E6000 from the same manufacturer, which may in fact be the same stuff). From the looks of the bulkhead, it appears to have been installed in at least two pieces, each glued into the kayak then to each other . Probably an easier way to get all that in through the hatch... Joe P. I recently acquired a used plastic boat made by Dagger, an 11' 6" "Blackwater" which I intend to use in conditions where I might stand a good chance of abusing my kevlar touring hull going through shallow, rocky bottom riffles, etc. This boat doesn't have any bulkheads. I intend to build-in a bulkhead behind the cockpit. I have heard that "normal" fiber glassing will not adhere to this plastic hull. I expect to make a pattern by cutting cardboard or something similar to the shape of the outside of the hull., a sort of a negative of the bulkhead. What would be a good material for the bulkhead itself? And what would be a good way to "glue" it in place? *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Mon Mar 18 2002 - 07:55:13 PST
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:51 PDT