Me again! getting noisy mmmhhh? I've recently been following courses (professionally) on 3M adhesives. They now have adhesives for polyethylene, which was impossible to glue until now or at least impossible to glue with a good structural resistance. They produce a 2 composant, very high resistance version, a hot melt version (called jet-melt No something) and even 2 sided adhesive tape. If any of you are interested in this glue, I'm sure you can find a 3M distributor near you, but please, PLEASE check the adhesives reaction to water immersion and sea water immersion before doing something silly. I have no info on water resistance. Maybe it's no use for kayaks, but still, maybe it'll give you Tupperware sailors an alternative to hot air welding. BTW, I have no commercial interest in promoting 3M or their products. I do work in the plastics industry here in Switzerland, and will do my best to answer any of your technical questions about plastics. Kevin Dyer *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:33:28 PDT