On Saturday, September 28, 2002, at 1:40:06 PM PST, Strosaker wrote: > My mistake was assuming that there was at least a 1/4 inch gap > between the seat and hull. After drilling the holes, I flipped the > kayak over just to make sure nothing happened, and after I looked, I > was in denial for about 5 minutes. Hi Duane, :-) You're right...it's a good idea to keep extra holes in the hull to a minimum! Even one unwanted hole could prove problematic. I got to paddle an Ellesmere once, and it's a very nice boat! Enjoy your launching! -- Melissa *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Sat Sep 28 2002 - 14:04:49 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:59 PDT