Duane, you neglected to tell us how many holes. If you paddle fast enough, they may help drain the cockpit... Strosaker wrote: > > Sea Kayakers, > > The recent posts about how much the first scratch on a new kayaks hurts made > me laugh due to something I did this past week. I just bought a brand new > fiberglass Boreal Design Ellesmere, which I will launch for the first time > tomorrow (Sunday). Of course, like every time I get a new or used boat, I have > to foam out the cockpit, change the deck arrangement a little, drill water > drain holes in the seat and so forth. Well, I had finished everything, except > for drilling holes in the seat. Now, I am experienced when it comes to using a > drill. I have 2 years of woodshop in high school, built 3 kayaks, and I am > always tinkering around. As I was drilling the holes through the seat, like I > had done many times before, I was careful not to push too hard so that the > drill bit wouldn't drop on down to the hull as it drilled through the seat. My > mistake was assuming that there was at least a 1/4 inch gap between the seat > and hull. After drilling the holes, I flipped the kayak over just to make sure > nothing happened, and after I looked, I was in denial for about 5 minutes. It > turns out the bottom of the seat is right on the hull. Repairing the holes in > the hull was easy, but it is going to take me a while to get over the > embarrassment. > > Duane -- gabriel l romeu ø http://studiofurniture.com ø ø http://journalphoto.org ø ø http://kayakoutfitting.org ø ø http://kayaknavigation.com ø *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Sat Sep 28 2002 - 15:00:33 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:30:59 PDT