I have this pump installed on my nordkapp, it works fine, however, I would suggest one thing: Take a tube of marine grade silicone and let loose a good ribbon around the switch/housing junction. Additionally, open up the unit and completely seal the switch and electrical leads inside the unit. You might even unscrew the switch and silicone the inside of the threads to the housing. My original Atwood failed because the seam between the switch boot and housing was not precise. I fixed that, though too late as the motor corroded and died. I spent 35 bucks and got another pump that has worked perfectly in the past few months. I trust it enough to no longer carry a backup, other than sponge and folding bailer. Cheers, Rob G *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Mon Feb 17 2003 - 07:50:28 PST
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:04 PDT