[AMF] > > > A curved deck is made up of (usually) 4 > > >pieces, one on the foredeck, one each side of the cockpit and one aft >deck. [WhiteRabbit] >Not sure on other CLC designs, but the Chesepeake 18 has only three pieces, >one aft deck that comes partway up the cockpit, one foredeck that extends >about from my hips to within ~2 feet of the bow, and a small bow piece that >fills in the remaining part of the deck. Which is inefficient use of plywood. However I can be accused of the same as I put in a lowered, flat, 400 mm aft deck for the rudder to land on and control lines to exit from under the curved aft deck. That means there's a cutout piece of ply (looking for something to be done with) from where the cockpit goes. Alex *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Tue Mar 04 2003 - 17:28:18 PST
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:04 PDT