Kayak fiberglass repair I have a dearly loved kayak that gets dragged up the beach a lot (better the boat than my body) I had a hole on the bottom under the back stern hatch that repaired with fiberglass and I have a fiberglass skid stip along the back keel. This weekend the epoxy and a layer of the fiberglass came off – the exact size and shape of the fiberglass repair. (rectangle) I’m looking for some good advise on how to redo this repair and also wondering if I can use stronger materials (kevlor, polyethelene…?) for the patch and for a new skid strip that might be tougher – not sure if I can marry these materials to fiberglass. The boat is an easy rider Eskimo double. Thank you! Adise is greatly appreciated! *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Tue May 13 2003 - 08:50:27 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:06 PDT